新发现,创新声卡驱动forMAC,KX小组出品

bonesong

有创新声卡的朋友对KX小组应该不陌生吧

我的AUDIGY2 ZS终于有用武之地了,而且还是KX出的驱动,爽阿

创新声卡的朋友可以去下载,下载地址http://drivers.mydrivers.com/dri ... .0b2-ALPHA-For-MAC/

最新发布的B3版本http://www.driverheaven.net/mac-os-x-driver/

[ 本帖最后由 bonesong 于 2008-8-18 03:10 编辑 ]

bonesong

多声道测试下来不行,但是前后声道倒是互换了,符合KX的习惯

换了B3的驱动以后,多声道测试正常,太强大了,8声道-32位

但是好景不长,听音乐听5分钟也没有的就开始有杂音了,郁闷,毕竟是测试阶段

[ 本帖最后由 bonesong 于 2008-8-18 03:35 编辑 ]

youminbuluo

呃
有人发过了啊

bingfenghuan

恭喜！
恭喜楼主了！

zanne

我用的b2，似乎只能听2声道。。。而且是后置的那个黑色口出声音，能多声道的吗?

starjzx

B2不行　再试试Ｂ3

senzhijun

不知道我的Creative SB PCI128 (CT4751) Sound Card 能不能用？有人和我的样的吗？我的在MAC下至今没出过声！

二丁目

虽然能响,不过噪音似的,只能一下一下地响,郁闷...

另外ALC888驱动,装了却根本没反应...

cerellean

有驱动了，我的SB0090有用了，重新燃起了我对MACOS的希望。pb90

axxx

好东西，终于来了。马上就试试看!

weida

EMU10K1 芯片终于能发挥动力了
等了那么久KX小组终于有点行动了
pb63 pb63 pb63 pb63 pb63

weida

原帖由 senzhijun 于 2008-8-31 05:24 发表
不知道我的Creative SB PCI128 (CT4751) Sound Card 能不能用？有人和我的样的吗？我的在MAC下至今没出过声！

这个不是EMU10K1芯片的.恐怕不行.KX小组专门为EMU10K1;EMU10K2 开发驱动的.

ryuila

哦也！这下可以重新玩mac了。

dongbin

那只能叫做创新部分声卡驱动了，好多卡还是无法使用的！

liqiyang

不错的发现啊

suzhan

新到1.1b版

http://www.driverheaven.net/mac- ... -released-beta.html

1.1b0 (BETA) version is finally out.

Changes:

* Fixed noise after 4-8 minutes
* Changed audio channels mapping, you no longer need to remap rear/center+sub channels in 'Audio MIDI Setup'
* Changed volume sliders: added mono 'master' slider, added volume controls for channels 3-8
* Fixed Leopard issue with notification sounds

Features:
* 16-bit and 24-bit playback on most 10k1/10k2 cards
* supports up to 8 speakers (configure speaker configuration in OS X 'Audio and MIDI' panel)
* should support SPDIF and headphones outputs, if applicable
* supports external modules (LiveDrive)
* supports hardware volume control and mute

Unimplemented:
* recording
* SPDIF/AC-3 passthrough
* 16/24-bit recording
* kX DSP and routing, no custom DSP effects, SDK and API
* hot-plug for PCMCIA device (Audigy2 ZS notebook) - surprise removal will probably cause a lock-up or kernel panic
* any sampling rate except 48000Hz not supported, OS X uses built-in SRC, which is quite good

Known issues:
* E-mu E-DSP cards are supported, but their FPGA firmware is not uploaded by default. If you are using Hackintosh, you will need to install kX driver, ensure audio is OK and reboot into OS X, this way FPGA firmware will be preserved and you will get audio.
* When installing under Leopard, you may need to reboot after you run the installer, because leopard won't load driver KEXT file

SACDCN

新版本还是

Unimplemented:
* recording

不支持录音

liyu-jake

听音乐听2分钟就开始有杂音

suzhan

原帖由 liyu-jake 于 2008-9-10 23:53 发表
听音乐听2分钟就开始有杂音

1.1b0版没有这个问题了，昨晚我用了很久，没事，各声道都可用